Long draw (spinning)

This MedLibrary.org supplementary page on Long draw (spinning) is provided directly from the open source Wikipedia as a service to our readers. Please see the note below on authorship of this content, as well as the Wikipedia usage guidelines. To search for other content from our encyclopedia supplement, please use the form below:

Related Sponsors

BM Pharmacy Generic pharmaceuticals at unbeatable prices. Insomnia, men's health, hair health, pain control. bmpharmacy.com
Online Pharmacy Carisoprodol, tadalafil, sildenafil, vardenafil and more... xlpharmacy.com
MedBasket.com Discreet. Inexpensive. Fast shipping. Great selection. What more can we say? medbasket.com
Frugalmed 2000 reasons to shop with us first. frugalmed.com
Ads by Tiva

A rolag- the starting point of a woolen yarn, which is spun with the long draw technique

Long draw is the spinning technique used to create woolen yarns. It is spun from carded rolags. It is generally spun from shorter stapled fibers. Long draw spun yarns are light, lofty, stretchy, soft, and full of air, thus they are good insulators,1 and make good knitting yarns.

Long draw spinning is most often contrasted to the short draw technique used to spin worsted yarns.

Contents

Technique

The first step to spin a true woolen yarn is to card the fiber into a rolag using handcarders.

The rolag is spun without much stretching of the fibers from the cylindrical configuration. The hand holding the fiber is the active hand, and the one closer to the wheel is passive. The passive hand smooths yarn, picks out vegetable matter, and pulls out extra bits of fluff,1 but that is all. The work of drafting is done by the active hand, and most of the regulation and smoothing of yarn is done by twist and tension.

Drafting is done by pinching off a short section of the rolag, and then pulling back while twist is added to it. The active hand pulls back until the yarn is the desired thickness. The passive hand controls how much twist is allowed in the drafting yarn: too much twist and the yarn won't draft; too little and the yarn will break. Twist concentrates in the thin areas of the yarn, solidifying these. Thus the tension doesn't stretch these parts thinner, but instead drafts the thicker parts until all the yarn is approximately the same thickness. This has the effect of automatically thinning out the thicker parts, which is what allows this technique to work.

Once the yarn is the desired thickness, enough twist is added to make the yarn strong. In effect, this is done by releasing the passive hand. Next the yarn is wound onto the bobbin, and the process starts again.

In use

Most handspinners make a blend of a woolen and worsted yarn, using techniques from both categories, and thus ending up with a mix, named a semi-worsted yarn.

References

  1. ^ a b Huebscher Rhoades, Carol. "Spinning Basics: The Long Draw." SpinOff Winter 2004: 74-76.

External links

v • d • e
Spinning
Materials:
Noil · Rolag · Roving · Sliver · Staple · Tow · Woolen · Worsted
Techniques:
Carding · Combing · Long draw · Short draw · Twist per inch
Tools:
Industrial Spinning:

Wikipedia content modification information:

  • This page was last modified on 4 November 2008, at 23:53.

Wikipedia Authorship and Review

Wikipedia content provided here is not reviewed directly by MedLibrary.org. Wikipedia content is authored by an open community of volunteers and is not produced by or in any way affiliated with MedLibrary.org.

Wikipedia Usage Guidelines

This article is licensed under the GNU Free Documentation License. It uses material from the Wikipedia article on "Long draw (spinning)".

The URL for this specific entry is:

All Wikipedia text is available under the terms of the GNU Free Documentation License. (See Copyrights for details). Wikipedia® is a registered trademark of the Wikimedia Foundation, Inc.