This MedLibrary.org supplementary page on Radial tire is provided directly from the open source Wikipedia as a service to our readers. Please see the note below on authorship of this content, as well as the Wikipedia usage guidelines. To search for other content from our encyclopedia supplement, please use the form below:
Related Sponsors
A radial tire (more properly, a radial-ply tire) is a particular design of automotive tire (in British English, tyre). The design was originally developed by Michelin in 1946 [1]. Because of its advantages, it has now become the standard design for essentially all automotive tires.
Tires are not fabricated just from rubber; they would be far too flexible and weak. Within the rubber are a series of plies of cord that act as reinforcement. All common tires (since at least the 1960s) are made of layers of rubber and cords of polyester, steel, and/or other textile materials. This network of cords that gives the tire strength and shape is called the carcass.
In the past, the fabric was built up on a flat steel drum, with the cords at an angle of about +60 and -60 degrees from the direction of travel, so they criss-crossed over each other. They were called cross ply or bias ply tires. The plies were turned up around the steel wire beads and the combined tread/sidewall applied. The green (uncured) tire was loaded over a curing bladder and shaped into the mould. This shaping process caused the cords in the tire to assume an S shape from bead to bead. The angle under the tread stretched down to about 36 degrees. This was called the Crown Angle. In the sidewall region the angle was 45 degrees and in the bead it remained at 60 degrees. The low crown angle gave rigidity to support the tread and the high sidewall angle gave comfort.
By comparison, radial tires lay all of the cord plies at 90 degrees to the direction of travel (that is, across the tire from lip to lip). This design avoids having the plies rub against each other as the tire flexes, reducing the rolling friction of the tire. This allows vehicles with radial tires to achieve better fuel economy than vehicles with bias-ply tires. It also accounts for the slightly "low on air" (bulging) look that radial tire sidewalls have, especially when compared to bias-ply tires.
Contents |
Construction
As described, a low radial tire would not be sufficiently strong and the surface in contact with the ground would not be sufficiently rigid. To add further strength, the entire tire is surrounded by additional belts that are oriented along the direction of travel. First made of tire cord, these belts were made of steel (hence the term steel-belted radial) by 1948 and subsequently Polyester or later Aramid fibers such as Twaron and Kevlar.
In this way, low radial tires separate the tire carcass into two separate systems:
- The radial cords in the sidewall allow it to act like a spring, giving flexibility and ride comfort.
- The rigid steel belts reinforce the tread region, giving high mileage and performance.
Each system can then be individually optimized for best performance.
Application
Radial tires have different characteristics of springiness from those of bias-ply tires, and a different degree of slip while steering. They ride differently; North American motorists were not accustomed to the feel. Hence the suspension systems of cars had to be modified. Ford Motor Company engineer Jack Bajer experimented in the 1960s on a Ford Falcon, by giving it less tight steering, and adding both isolators to the drive shaft and bushings to the suspension, the latter being to absorb the thump of riding over asphalt expansion joints in a concrete roadway. Cars could now be made lighter because they would not have to make up for the deficiencies of bias-ply tires.1
Radial tires have only once found application on bicycles, used on the 1980s Miyata touring bicycle models 1000 and 610.2
External links
References
- ^ Moran, Tim (2001-04-28). "The Radial Revolution". Invention & Technology Magazine. American Heritage Publishing. Archived from the original on 2007-12-26. Retrieved on 2008-08-07.
- ^ Sheldon Brown: Japanese cycles in the American market: http://www.sheldonbrown.com/japan.html#miyata
Wikipedia content modification information:
- This page was last modified on 21 November 2008, at 18:49.
Wikipedia Authorship and Review
Wikipedia content provided here is not reviewed directly by MedLibrary.org. Wikipedia content is authored by an open community of volunteers and is not produced by or in any way affiliated with MedLibrary.org.
Wikipedia Usage Guidelines
This article is licensed under the GNU Free Documentation License. It uses material from the Wikipedia article on "Radial tire".
The URL for this specific entry is:
All Wikipedia text is available under the terms of the GNU Free Documentation License. (See Copyrights for details). Wikipedia® is a registered trademark of the Wikimedia Foundation, Inc.