This MedLibrary.org supplementary page on Thermal conductivity measurement is provided directly from the open source Wikipedia as a service to our readers. Please see the note below on authorship of this content, as well as the Wikipedia usage guidelines. To search for other content from our encyclopedia supplement, please use the form below:
Related Sponsors
Two classes of methods exist to measure the thermal conductivity of a sample: steady-state and non-steady-state methods.
Steady-state methods
(In Geology/Geophysics) The most common method for consolidated rock samples is the Divided Bar. There are various modifications to these devices depending on the temperatures and pressures needed as well as sample sizes. A sample of unknown conductivity is placed between two samples of known conductivity (usually brass plates). The setup is usually vertical with the hot brass plate at the top, the sample in between then the cold brass plate at the bottom. Heat is supplied at the top and made to move downwards to stop any convection within the sample. Measurements are taken after the sample has attained equilibrium (same heat over entire sample), this usually takes about 10 minutes.
Transient methods
Non-steady-state methods to measure the thermal conductivity do not require the signal to obtain a constant value. Instead, the signal is studied as a function of time. The advantage of these methods are that they can in general be performed more quickly, since there is no need to wait for a steady-state situation. The disadvantage is that the mathematical analysis of the data is in general more difficult.
Transient line source method
The physical model behind this method is the infinite line source with constant power per unit length. The temperature profile T(t,r) at a distance r at time t is as follows
where
- Q is the power per unit length, in W·m-1
- k is the thermal conductivity of the sample, in W·m-1·K-1
- Ei(x) is the exponential integral, a transcendent mathematical function
- r is the radial distance to the line source
- a is the thermal diffusivity, in m2·s-1
- t is the amount of time that has passed since heating has started, in s
When performing an experiment, one measures the temperature at a point at fixed distance, and follows that temperature in time. For large times, the exponential integral can be approximated by making use of the following relation
- Ei(x) = − γ − ln(x) + O(x)
where
is the Euler gamma constant
This leads to the following expression
Wikipedia content modification information:
- This page was last modified on 9 May 2008, at 11:14.
Wikipedia Authorship and Review
Wikipedia content provided here is not reviewed directly by MedLibrary.org. Wikipedia content is authored by an open community of volunteers and is not produced by or in any way affiliated with MedLibrary.org.
Wikipedia Usage Guidelines
This article is licensed under the GNU Free Documentation License. It uses material from the Wikipedia article on "Thermal conductivity measurement".
The URL for this specific entry is:
All Wikipedia text is available under the terms of the GNU Free Documentation License. (See Copyrights for details). Wikipedia® is a registered trademark of the Wikimedia Foundation, Inc.